Photo by Mika Baumeister

Broken Headphone Jack: Fix It With These Tips!

One of the most frustrating things about owning an electronic device is when the headphone jack breaks. It’s a common issue that can cost you thousands of dollars in repairs, and it’s one you don’t want to have to deal with. Fortunately, there are a few things you can do to fix a broken headphone jack without having to go to a professional. This article will show you how to fix a broken headphone jack without any tools.

The Problem

If you’re experiencing problems with your headphones, there are a few things you can do to fix them. The most common cause of headphone issues is a broken jack. Here’s how to fix it:

1. Remove the headphones from your laptop or phone and unplug them from the port.

2. Inspect the jack for damage. If there is evident damage, replace the jack. If there is minor damage, try these steps:

3. Bend both metal contacts back slightly so that they touch each other again. This should make the connection stronger and prevent further damage to the jack.

4. Replace the jack if necessary.

bent headphone jack

The Solution

If your headphone jack is broken, don’t panic! There are a few simple steps you can take to repair it yourself. First, try to identify the part that’s broken. This can be tricky, as the jack may look intact but have a loose wire inside. If you’re still unable to identify the broken part, you can try using a voltmeter to check for voltage at the jack.

If there’s no voltage present, then the jack is likely broken. In either case, you have to replace the part that’s broken. There are many available replacement parts online or at your local hardware store. Once you’ve replaced the part, test the new one by plugging in your headphones and ensuring they work correctly.

What You Will Need

If you have a broken headphone jack on your device, there are a few simple things you can do to fix it. You will need the following:

– A Phillips screwdriver;

– A piece of wire about the size of your headphone jack;

– A small amount of super glue. You can use a standard screwdriver if you don’t have a Phillips screwdriver.

How to Fix a Broken Headphone Jack

There are a few ways to fix a broken headphone jack. The first is to use a paper clip. Push the broken piece of the headphone jack out as far as possible, and then put the paper clip between the headphone jack and the phone case. Pry until the plug comes loose. If that doesn’t work, try using a tool that fits into the tiny hole on the side of an iPhone and pull until the plug comes off. Finally, you can get a new headphone jack from Apple or another supplier if everything fails.

Or you can do this:

1. Remove the battery cover on your device.

2. Use the Phillips screwdriver to remove the three screws holding the battery.

3. Once the screws have been removed, gently pull the battery out.

4. Carefully peel off the old adhesive backing from the headphone jack.

5. Apply a small amount of superglue to the end of the wire, and slide it into the headphone jack until it rests against the housing of the jack. Ensure the wire is firmly pressed against both sides of the housing.


If your headphone jack is broken, there are a few things you can do to try and fix it. You may be able to use a metal object to try and pry open the phone’s casing enough so that you can replace the jack. Or, you may be able to use a different type of screwdriver that design is specifical for repairing electronic devices. Thanks for reading!

Leave A Reply

Your email address will not be published.